Home Brake Alignment Tool

Brake Alignment Tool

x

Hayes Brake Pad and Rotor Alignment Tool Purple

$18.99

Tired of your disc brakes rubbing? The Hayes Brake Pad and Rotor Alignment Tool is exactly what you need! Two thin leaves of flexible steel insert into the caliper between the rotor and pad, spacing the pads evenly and aligning the caliper with the rotor. To use, simply loosen the caliper bolts, then insert the tool. After tightening down the caliper bolts, removal of the tool will result in evenly-spaced pads and no more brake ...

x

Park Tool Pp-1.2 Hydraulic Piston Press Pp-1.2

$19.95

Park Tool PP-1.2 Hydraulic Piston Press The unique, wedge-shaped PP-1.2 slides into a hydraulic disc brake caliper to pre-set the piston when replacing pads, aligning pads, and performing other service procedures. This handy little tool makes hydraulic disc brake maintenance and repair faster and easier. Features Manufacturer's Part No: PP-1.2 UPC: 763477004826 | Park Tool Pp-1.2 Hydraulic Piston Press Pp-1.2

x

Park Tool Obw-3 Offset Brake Wrench Silver, 14mm & Caliper Spring Adjust

$7.95

Park Tool OBW-3 Offset Brake Wrench The Park Tool OBW-3 Offset Brake Wrench features a unique design that was specifically made to be used in tight spaces. It has a 14mm opening on one end and a caliper aligning tool on the other end, which fits right into the springs and allows you to rotate the caliper on its bolt. Features 14mm Related Articles: SIDE PULL BRAKE SERVICE Manufacturer's Part No: OBW-3 UPC: 763477004857 | ...

x

Park Tool Disc Brake Mount Facing Tool Dt-5.2

$445.95

Park Tool Disc Brake Mount Facing Tool Engineered and built to accurately face front or rear disc brake mounts to be precisely aligned to rotor. Features Works on both post mounts and IS brake mounts Low clearance to access chainstay post mounts Works on 100mm width open dropout forks, 100mm width 15mm thru axle forks, and 20mm thru axle forks Telescoping axle adaptors allow use with any configuration of open or thru-axle dropouts and dropout ...